Oracle X7 series, Руководство администратора

Страница: 23 / 118

Cable the Server to Connect to Oracle ILOM
Management
Connection
Management Port Description
Note - The Host-to-ILOM Interconnect is also known as the Dedicated Interconnect SP
Management Connection .
Cable the Server to Connect to Oracle ILOM
1. Determine the type of connection to Oracle ILOM that best suits your
environment.
For information about management connections to Oracle ILOM, see “Oracle ILOM
Management Connection Options” on page 22 .
2. To establish a dedicated remote network management connection to Oracle
ILOM:
a. Connect an Ethernet cable between the NET MGT port on the server and the
network switch.
DHCP and IPv6 stateless auto-configuration are enabled by default, allowing a DHCP
server on the network to automatically assign network settings to the service processor
(SP).
b.
Determine the IP address assigned to the server SP.
Establish a serial connection to Oracle ILOM, and then view the properties under the
/network
and
/network/ipv6
hierarchies.
c. Type the IP address or host name into a browser address bar.
The Oracle ILOM Login dialog box appears.
For further instructions, see
“Launch and Log In to Oracle ILOM Through a Remote
Ethernet Connection” on page 24 .
3. To establish a local serial management connection to Oracle ILOM, perform the
following steps:
a. Connect a serial cable between the SER MGT port on the server and a
terminal device.
This connection provides your initial communication with the server service processor
(SP). Configure the terminal device with the following settings: 9600 baud, 8 data bits, 1
stop bit, and no parity (9600/8-N-1).
Accessing and Using System Administration Tools 23