Oracle Sun Server X4-4, Руководство по установке, Страница: 64 / 148

Testing Network Settings for Oracle ILOM
■
IPv6: To set a static IPv6 address, ensure that the Enabled check box next
to the State property is selected. Then, type the static address in the format
ipv6_address
/
subnet mask length in bits
in the Static IP Address field (for example:
fec0:a:8:b7:214:4f ff:feca:5f7e/64
) and click Save.
4. Test the IPv4 or IPv6 network configuration from Oracle ILOM using the Network
Test Tools (Ping and Ping 6).
For details, see “Test IPv4 or IPv6 Network Configuration From the Oracle ILOM Web
Interface” on page 65 .
Testing Network Settings for Oracle ILOM
The procedures in this section describe how to test Oracle ILOM network settings.
■
To test network setting from the Oracle ILOM CLI, see “Test IPv4 or IPv6 Network
Configuration From the Oracle ILOM CLI” on page 64 .
■
To test network settings from the Oracle ILOM web interface, see “Test IPv4 or IPv6
Network Configuration From the Oracle ILOM Web Interface” on page 65 .
Test IPv4 or IPv6 Network Configuration From the
Oracle ILOM CLI
1.
Use the
cd
command to navigate to the
/SP/network/test
directory:
->
cd /SP/network/test
2.
At the CLI prompt, type the
show
command to view the network
test
targets and
properties.
For example, the following output shows the test target properties.
-> show
/SP/network/test
Targets:
Properties:
ping = (Cannot show property)
ping6 = (Cannot show property)
64 Sun Server X4-4 Installation Guide • October 2015