Oracle SPARC T7-2, Руководство по обслуживанию

Страница: 45 / 188

Clear a Fault Manually
Oracle ILOM Properties That Affect POST
Behavior
There are a number of Oracle ILOM commands that you can use to perform host diagnostic
tests. For details about using these commands, refer to the chapter that describes configuring
host server management actions in the Oracle ILOM Administrator's Guide for Configuration
and Maintenance Firmware Release 3.2.x .
Related Information
■
“POST Overview” on page 42
■
“Configure POST” on page 42
Clear a Fault Manually
When the server detects faults, the faults are logged and displayed on the console. In most
cases, after the fault is repaired the fault condition is repaired automatically. In cases where the
fault condition is not automatically cleared, you must clear the fault manually.
1. After replacing a faulty component, power on the server and, verify that the fault
for that component has cleared.
Use the
fmadm faulty
command to confirm that the fault is clear.
2.
Determine your next step.
■
If no fault was detected, you do not need to do anything else. Do not perform
the subsequent steps.
■
If a fault was detected, continue to the next step.
3. Clear the fault from all persistent fault records.
In some cases, even though the fault is cleared, some persistent fault information remains
and results in erroneous fault messages at boot time. To ensure that these messages are not
displayed, type:
faultmgmtsp> fmadm acquit
UUID/NAC-name
Detecting and Managing Faults 45