Oracle netra X5-2, Руководство по установке

Страница: 92 / 152

Deploying the OCI Instance
The OCI instance configuration procedure includes a multi-dialog wizard that presents
configuration options in the preferred sequence. The result of this wizard is an
installed, operational OCSBC or two HA OCSBC instances with management
networking only. Having completed the pre-requisites, OCI is able to display objects,
including network/subnets and Security Groups, for you to simply select during
deployment.
Deploying the OCSBC on OCI, whether or not you are using HA, includes the following
high-level steps:
1.
Upload Image
2.
Select Shape
3.
Create Instance
4.
Attach the Network Interfaces to Your Instances—Check your interface
assignments using the OCSBC ACLI interface-mapping commands after OCSBC
startup and correct interface assignment, if necessary. See the Oracle®
Communications Session Border Controller Platform Preparation and Installation
Guide for further instructions on using these commands.
5.
Create a Console Connection.
6.
Apply the OCSBC Configuration—This is an OCSBC ACLI configuration
procedure.
The OCI workspace may present dialogs and fields that differ from this procedure. For
full information on deploying OCI instances, see the Oracle OCI documentation.
Upload Image
The OCSBC is not available as a pre-packaged image on OCI. You must upload the
OCSBC disk file to a Bucket and create a Custom Image that you can then use when
creating an OCSBC instance. Note that the file you upload must be in qcow2 format
1.
Click the Hamburger menu to display the drop-down menu and click Object
Storage > Object Storage.
2.
If there is no Bucket available to store the disk file in the Compartment, create one
by clicking the Create Bucket button.
3.
After creating your Bucket, select it and click the Upload Object button.
4.
From the Upload Object dialog, locate your qcow2 image and upload it to the
bucket.
5.
From the overflow menu, which appears as three dots (elipses) at the bottom
right corner of the bucket's dialog, click Create a pre-authenticated request for
access to the stored object from the Custom Image.
6.
Enable Read/write permissions by selecting the PERMIT READ ON AND WRITES
TO THE OBJECT radio button from the Create Pre-Authenticated Request
dialog.
7.
Click the Create Pre-Authenticated Request button.
Chapter 7
Create and Deploy on OCI
7-26