c.
Guide the cables through the tab opening in the base plate.
d.
Attach the 10-Inch Customer Display with Pole Mount to the cash drawer or
other surface using the four #8-32 base plate screws.
2.
To attach the 10-Inch Customer Display with Pole Mount to surfaces with a cable
routing hole:
a.
Tighten the pole base plate captive screws, if required.
b.
Guide the cables through cable routing hole.
c.
Attach the 10-Inch Customer Display with Pole Mount to the surface using the
four #8-32 base plate screws.
3.
Connect the 10-Inch Customer Display with Pole Mount power cord and HDMI
cable to the Workstation 6 Series I/O panel.
4.
To power on the 10-Inch Customer Display with Pole Mount, press the power
button on the rear of the unit.
Calibrating the Workstation and 10-Inch Customer Display
Follow the steps below to calibrate the workstation and 10-Inch Customer Display:
Microsoft Windows 10
1.
Connect the 10-Inch Customer Display to a Workstation 6 Series workstation.
2.
Connect a mouse to the workstation.
3.
Right-click the desktop, and then select Display settings from the popup menu.
4.
Click Extend These Displays, and then click Keep These Changes.
5.
Open the Control Panel, and then click Tablet PC Settings.
6.
In the Display Options box, verify that “1. Mobile PC Display” appears in the
drop-down list.
7.
In the Configure box, click Setup, and then touch the workstation screen when
“Touch this screen to identify it as the touchscreen” appears.
8.
Click OK to exit Tablet PC Settings.
9.
Double-click Intel HD Graphics Control Panel, and then select Display.
10.
Verify Select Display is set to Built-in Display.
11.
From the Resolution drop-down list, select 1920 x 1080, click Apply, and then
click Yes to continue.
12.
Right-click the taskbar, and then click Properties. In the Multiple Displays area,
click to turn off Show taskbar on all displays to disable the taskbar on the 10-
Inch Customer Display.
Installing the Power USB Module
The Workstation 625/655 supports an optional power USB module. The hex key is
required for installation.
1.
Place the Workstation 6 Adjustable Stand on its back.
Chapter 4
Calibrating the Workstation and 10-Inch Customer Display
4-20
