Installing the 10-Inch Customer Display with Pole Mount
1.
To attach the 10-Inch Customer Display with Pole Mount to a cash drawer or other
surface without a cable routing hole:
a.
Tighten the pole base plate captive screws, if required.
b.
Use pliers or similar tool to break off a cable routing tab located along the rear
edge of the pole base plate.
c.
Guide the cables through the tab opening in the base plate.
d.
Attach the 10-Inch Customer Display with Pole Mount to the cash drawer or
other surface using the four #8-32 base plate screws.
2.
To attach the 10-Inch Customer Display with Pole Mount to surfaces with a cable
routing hole:
a.
Tighten the pole base plate captive screws, if required.
b.
Guide the cables through cable routing hole.
c.
Attach the 10-Inch Customer Display with Pole Mount to the surface using the
four #8-32 base plate screws.
3.
Connect the 10-Inch Customer Display with Pole Mount power cord and high
definition display cable to the Workstation 6 Series I/O panel.
4.
To power on the 10-Inch Customer Display with Pole Mount, press the power
button on the rear of the unit.
Calibrating the Workstation and 10–Inch Customer Display
Follow the steps below to calibrate the workstation and 10-Inch Customer Display:
WS610 with Microsoft Windows 10 or Microsoft Windows 8.1
1.
Connect the 10-Inch Customer Display to a Workstation 6 Series workstation.
2.
Connect a mouse to the workstation.
3.
For Windows 10, right-click the desktop, and then select Display settings from
the popup menu. For Windows 8.1, right-click the desktop, and then select
Graphics Options from the popup menu.
4.
For Windows 10, click Extend These Displays, and then click Keep These
Changes. For Windows 8.1, click Output to, click Extend Desktop, and then click
Built-in D Digital television.
5.
Open the Control Panel, and then click Tablet PC Settings.
6.
In the Display Options box, verify that “1. Mobile PC Display” appears in the
drop-down list.
7.
In the Configure box, click Setup, and then touch the workstation screen when
“Touch this screen to identify it as the touchscreen” appears.
8.
Click OK to exit Tablet PC Settings.
9.
Double-click Intel HD Graphics Control Panel, and then select Display.
10.
Verify Select Display is set to Built-in Display.
Chapter 6
Installing the 10-Inch Customer Display with Pole Mount
6-22
