4.
Mark the position of the hole for the fifth foot on the counter, and then use a drill to
create the hole.
5.
Place the Adjustable Stand on the counter and align the hole for the fifth foot to its
matching hole on the counter.
6.
Secure the Adjustable Stand to the counter using a mounting screw. The mounting
screw is not provided. Ensure that you are using the correct screw that meets the
needs of the installation. The screw thread is M4 and the length is a minimum of
one inch plus the thickness of the counter.
Installing the High-Mount Customer Display on the
Adjustable Stand
The High-Mount Customer Display is only available for the revised MICROS
Workstation 6 Series Adjustable Stand (see Prerequisites). The display and bracket
are provided as a complete assembly and ready for installation.
Prerequisites:
•
Workstation 6 Series Adjustable Stand with High- and Low- Mount Customer
Display Options (Part Number: 7114626)
•
High-Mount Customer Display and Bracket Assembly (Part Number: 7114627)
•
No. 2 (1/4 in.) Phillips screwdriver
To install the High-Mount Customer Display on the Workstation 6 Series Adjustable
Stand:
1.
Place the Adjustable Stand upright on a flat surface, and then tilt the mounting
plate upwards to a vertical position.
2.
Remove the High-Mount slot cover.
Chapter 6
Installing the High-Mount Customer Display on the Adjustable Stand
6-20
