Oracle Exadata Storage Server X7-2 EF, Руководство по обслуживанию

Страница: 45 / 284

Assign Serial Port Output Using the Oracle ILOM Web Interface
4. In the Serial Port Settings page, select
Host Server
as the serial port owner.
5.
Click
Save
for the changes to take effect.
6. Connect a serial host to the server.
Ethernet Device Naming
This section contains information about the device naming for the one 10-Gigabit Ethernet port
(labeled NET 0) on the back panel of the server. For location information, see “Back Panel
Connector Locations” on page 42 .
Ethernet Port Device Naming
The device naming for the Ethernet interface is reported differently by different interfaces
and operating systems. The following table shows the BIOS (physical) and operating system
(logical) naming convention for the interface. This naming convention might vary depending on
the conventions of your operating system and which devices are installed in the server.
Note - Naming used by the interfaces might vary from that listed below depending on which
devices are installed in the system.
Port Solaris Linux Windows
NET 0 igb0 ■ Linux 6 - eth0
■ Linux 7 - enp1 Ethernet
Note -
For Windows, port naming such as
Ethernet is used by default. Windows allows
you to rename the ports to meet application-
specific needs.
Back Panel Pinhole Switches
Oracle Service personnel might instruct you to use the back panel pinhole switches to reset the
NMI, Host Warm Reset, or SP, as shown in the following figure.
Troubleshooting and Diagnostics 45