Oracle Acme Packet 4500, Руководство по установке и обслуживанию оборудования

Страница: 88 / 114

82 Acme Packet 4500 Hardware Installation and Maintenance Guide
MAINTENANCE
4. Screw the two captive screws through the fan module and into the chassis using
a #2 Phillips screwdriver.
Figure 6 - 111. Tightening Thumbscrews
Note: Ensure that you hear the exhaust fans spinning and feel air
exhausted through the rear of the chassis.
5. Place the black foam air filter onto the fan module, ensuring that the center slot
in the air filter slides over the fan module pull tab.
Figure 6 - 112. Re-Installing the Air Filter
6. Insert the tab on the right-side of the fan bezel into the stationary control panel
slot.
7. Pivot the fan bezel toward the chassis so that the left-side of the bezel clips snap
into the chassis.
Figure 6 - 113. Re-Installing the Fan Bezel
Maintaining the
Cooling
Components
The Acme Packet 4500 air filter removes airborne particles before they are drawn
into the Acme Packet 4500 chassis. To prevent system malfunction and prolong the
life of the system cooling components, follow these guidelines:
•
Clean or replace the air filter every three months.
•
Clean the air inlets once a week.
Cooling maintenance encompasses cleaning the fan module and cleaning the air
inlets on the front of the Acme Packet 4500 chassis. Cleaning the fan module
requires that you remove the module itself. If you are not shutting down the Acme
Packet 4500, this procedure must be performed quickly; otherwise, the system may
overheat and cause packet processing to stop.
This maintenance should be performed alongside other preventative maintenance to
take place within a planned maintenance or downtime window, during off-peak
hours.