OPW M00-051.00 FSC3000, Руководство по настройке через командную строку

Страница: 81 / 181

12.4.8 Odometer Reasonability
The
Odometer Reasonability
option is not recommended for multi-site systems. This option is available
when “save odometer entries” is selected. This option allows for the selection of an Odometer restriction
code for a Single or Vehicle Card that will reference the Odometer Reasonability Table. When a transaction
is performed, the currently entered odometer is checked against the previous stored odometer in the card file.
The difference is then compared to the odometer reasonability table with the code defined for that card. If the
mileage traveled is equal to or above the lower range and equal to or below the upper range the odometer is
considered reasonable and the transaction will continue. If the transaction mileage is higher than the upper
limit, or lower than the lower limit, the transaction mileage entry is considered unreasonable and the system
will respond in one of two ways. This option must be enabled in order to use “Tiered Accounts”.
Add information when using tiered accounts for the odometer reasonability field.
Accept the third bad entry and fueling is allowed
Reject the third bad entry and terminate transaction
NOTE:
Odometer Reasonability Table Setup is required (if applicable).
12.4.9 Product Restriction
The Product Restriction option allows for the definition of a product restriction code to be assigned to
each card/account. This code defines which product(s) can be accessed. If product restriction may be
needed at a later date, enable this option and assign each card a code 00 for unrestricted.
Common Use
: Single Cards (associated to vehicles) and Vehicle Cards (dual-card system) will restrict the
vehicle to the fuel type it uses.
NOTE:
Odometer Reasonability Table Setup is required (if applicable).
12.4.10 Quantity Restriction
The
Quantity Restriction
option allows for the definition of a quantity restriction code for each card/account
in order to limit how much fuel each transaction can pump. If Quantity Restriction may be needed at a later
date, enable this option and assign each card a code 00 for unrestricted. The Quantity Restriction option can
be set up to limit either by quantity or monetary, but not both.
Common Use : Single cards (associated to vehicles) and Vehicle cards (dual-card system) restrict the
transaction from pumping more than the tank size of the vehicle.
NOTE:
Quantity Restriction Table Setup is required (if applicable).
Doc. No.: M00-051.00 Rev.: 10
Page 81 of 181