OPW M00-051.00 FSC3000, Руководство по настройке через командную строку

Страница: 52 / 181

Dedicated Terminal
– When FIT access to pumps is limited to one specific pump, the terminal will behave in
the following way:
The FIT will not prompt for pump #.
When the transaction is finished and the terminal is set up for receipts, the terminal will prompt for receipt.
The system will then display what is configured:
Current Type: DTC Terminal
Change FIT Type (Y/N)? N
Enter Decline Message Timeout seconds: 15
Enter Prompt Timeout Code (1…9): 1
Issue Receipts (Y/N)? y
--Enter limit to receive receipts in days (0..99): NO Limit
--Clear Receipt Counter (Y/N)? N
DISABLE Keyboard Access (Y/N)? N
Enter Keyboard Length (1…32): 32
Clear Card Reader Error Counter (Y/N)? N
Change FIT Access To Pumps (Y/N)? N
FIT Installed
FIT INFO: CAT
CRIND
CRAD 1.2.5974
Island Terminal: DTC Terminal
Decline Timeout: 15 SECONDS
Prompt Timeout: 15 SECONDS
Receipts: 2 NO Limit To Receive Receipt
Keyboard Access --ENABLED………Length: 32
Card Reader Error Counter: 2
LIST OF VALID PUMPS: 1
Or, if changing the FIT type, then the system will display the following:
Current Type: DTC Terminal
Change FIT Type (Y/N)? y
Is this a DTC (Y/N)? Y
Is this a FIT500 (Y/N)?
Is this a C/OPT (Y/N)?
Is this a K800 FIT (Y/N)?
Enter Decline Message Timeout seconds: 15
Enter Prompt Timeout Code (1…9): 1
Issue Receipts (Y/N)? y
--Enter limit to receive receipts in days (0..99): NO Limit
--Clear Receipt Counter (Y/N)? N
DISABLE Keyboard Access (Y/N)? N
Enter Keyboard Length (1…32): 32
Specify PCTs to shut-off on E-Stop (Y/N)? N
Clear Card Reader Error Counter (Y/N)? N
Change FIT Access To Pumps (Y/N)? N
7.1.2 Install FIT # (1 to 8)
This setting indicates to the system that the FIT is available and may communicate with it.
Doc. No.: M00-051.00 Rev.: 10
Page 52 of 181