OPW M00-051.00 FSC3000, Руководство по настройке через командную строку

Страница: 155 / 181

Section 16 Transaction Management
16.1 Set Transaction
The Set Transactions option defines how the transaction buffer will handle and display transaction
information.
16.1.1 Wrap Around
IMPORTANT:
If using proprietary, wraparound is not recommended as transactions could be
lost.
The
Wrap Around
option defines how a transaction should be handled when the transaction buffer is full. If
this option is disabled the system will prevent new transactions and display “SYSTEM BUSY – BUFFER
FULL” when one is initiated. The user will then retrieve and clear transactions (poll) before a new one can be
started. If enabled, the system will always allow fueling when the transaction buffer is full, but will overwrite
the oldest transaction. This is not recommended when processing proprietary cards.
16.1.2 Write Over NON-CAPTURED or FAILED Transactions
The
Write Over NON-CAPTURED or FAILED Transactions
option defines whether the network
transactions that have not been captured or failed should be written over. This option is available when the
“Wrap Around” option is enabled.
16.1.3 Redefine Transaction
TRANS = Unauthorized users also. The Redefine Transaction option saves transaction buffer space by
storing only transactions of authorized users (Declined network cards will always be saved). If set to “no” the
system will not save unauthorized proprietary cards and any network cards invalid on the ISO table.
NOTE:
When set to “no," some unauthorized transactions can be assigned a transaction
number, but when terminated will not save, causing transaction number gaps in the
transaction buffer.
16.1.4 Specified Display Fields
The
Specified Display Fields
option defines which fields will be displayed when performing show
commands and/or polling of transactions.
To set Transaction options type:
Set Transaction <ENTER>.
Doc. No.: M00-051.00 Rev.: 10
Page 155 of 181