38 English
APPENDICES
Projector Problems
The projector stops responding to all controls
If possible, turn off the projector, then unplug the power cord and wait at least 60 seconds before reconnect
-
`
ing power.
Check that “Keypad Lock” is not activated by trying to control the projector with the remote control.
`
If the remote control does not work
Check if the operating angle of the remote control is within ±30° both
`
horizontally and vertically on one of the IR receivers on the projector.
Make sure there is no obstruction between the remote control and the projector. Move to within 12 m (±0°)
`
of the projector.
Make sure the batteries are inserted correctly.
`
Replace batteries if they are exhausted.
`
Ensure that you have set your remote to the correct IR code setting.
`
When making a direct connection from your computer to the projector
If you have network connection problem from your computer to the projector, please refer to the computer
`
setting as below or contact with web administrator.
Step 1: Find an IP Address (192.168.0.100) from LAN function of projector.
Step 2: Select “Apply” and push the “Enter” button. Once the setting is saved, exit the OSD by pushing
“Menu” button.
Step 3: To open Network Connections, click
Start
, click
Control Panel
, click
Network and Internet
Connections
, and then click
Network Connections
. Click the connection you want to configure, and
then, under
Network Tasks
, click
Change settings of this connection
.
Step 4: On the
General
tab, under
This connection use the following items
, click Internet Protocol(TCP/
IP), and then click “
Properties
”.
Содержание ZH510Te
Страница 1: ...User s Manual DLP Projector ...
Страница 49: ...www optoma com ...