OPTO 22 SNAP PAC R SERIES, Руководство пользователя

Страница: 15 / 82

SNAP PAC R-Series Controller User’s Guide
7
7
2: Installation
If you already know how you will use the SNAP PAC R-series controller and want to get it running quickly,
follow the sections in this chapter.
To learn about communication options and networking, start on page 13 . Specifications are listed on page 29 .
WHAT YOU WILL NEED
You’ll need the following items to install a SNAP PAC R-series controller:
• A PC running one of the following operating systems:
–
Microsoft® Windows® 10 Professional (32-bit or 64-bit)
– Microsoft Windows 7 Professional (32-bit or 64-bit)
• For an Ethernet connection , the PC also needs a 10/100 MB Ethernet adapter card, the TCP/IP protocol
installed, and a valid IP address, on the same subnet as the brain. (For more information, see
“Networking” on page 22 .) In addition, you need a standard Ethernet cable for direct connection to the
PC (recommended), or an available connection to a standard 10BASE-T or 100BASE-TX Ethernet network.
• NOTE: Wired+Wireless models must be initially configured using a wired interface. Once IP addresses and
wireless communication parameters are set, the brain can be used wirelessly.
• SNAP PAC R-series controller
• SNAP PAC mounting rack and SNAP I/O modules. Choose rack and modules based on your needs.
(Exception: a SNAP-PAC-R1-B uses a B-series rack, not a SNAP PAC rack.)
• A SNAP-PS5 or SNAP-PS5U power supply or other 5 VDC power supply (5.0 to 5.2 VDC at 4.0 A) applied to
the rack. Additional power may be required for SNAP I/O modules and depends on the number and type
of modules used. For more information, see
“Determining Power Requirements” on page 67 .
• (Recommended) PAC Project Basic or PAC Project Professional (available from the Opto22 website)
INSTALLING HARDWARE
Assemble the rack and power supply according to the directions that came with them. For help with wiring,
see the product data sheets, which are available on our website at
www.opto22.com .
Installing Modules on the Rack
CAUTION:
Make sure you are using the correct rack for your controller. All SNAP PAC R-series controllers except the
SNAP-PAC-R1-B use a SNAP PAC rack. SNAP-PAC-R1-B uses a B-series rack (with a B in the part number; this controller
does not work on a SNAP-D64RS rack). Using the wrong rack will severely damage the controller.