MAINTENANCE
groov
Box User’s Guide for GROOV AT1
56
Resetting the
groov
Box to factory defaults
Restoring the
groov
Box restores the default network settings and erases all user data, including your
project. When the process is complete, the Box will send out a DHCP request on ETH0, and you will
be able to connect using the default hostname.
CAUTION
: When the groov
Box is restored to factory default settings, your project will be erased.
1.
Check to see that the
groov
Box is turned off, but the PWR LED is on.
2.
Press and hold the On/Off button for at least four seconds and until the STOR LED is blinking
orange. Then release the button.
Both the SYS LED and STOR LED will be blinking orange at this point. When both the SYS LED
and STOR LED stop blinking orange, the procedure is finished.
3.
Briefly press the On/Off button to turn off the
groov
Box, then briefly press it again to turn the
groov
Box back on so that you can log in.
Maintaining the fan filters
Be sure you check and clean the fan filters periodically and replace them when necessary. How often
you do this will depend on the installation environment. If the fan filters on the
groov
Box become
clogged, they can be re-used. A pair of extra filters is also provided.
1.
Pry off the outer cover using a small utensil around the outer edge.
2.
Remove the old filter.
3.
Rinse and pat dry the old filter, or replace it with a new one.
4.
Using your fingers, snap the outer cover back into place.
Содержание GROOV BOX
