Optimum Optimum 3292385, Руководство по эксплуатации, Страница: 35 / 80

Operation
Version 1.0.4 - 2020-10-13 35 Translation of original instruction
SD500AV EN
SD500A
V_G
B
_4.
fm
4.8 Adjusting the saw band guide
ATTENTION!
An unnecessarily wide space between the work piece and the saw band guide, in combi-
nation with a high feed rate very quickly causes the saw band to wear down.
Change the position of the saw band guide (4) depending on the size of the parts to be sawn.

Loosen the clamping screw.

Adjust the saw band guidance close to the workpiece without influencing or hindering the
sawing procedure.

Re-tighten the clamping screw.
4.9 Coolant equipment
ATTENTION!
Destruction of the pump due dry running. The pump is lubricated by the coolant. Do not
operate the pump without coolant.
If necessary, switch on the coolant device on the control panel and dose the supplied quantity
at the dosing valves.
INFORMATION
Use as cooling agents a water soluble, ecologically harmless sawing emulsion, which they can
refer in the specialized trade. Make sure that the cooling agent is properly retrieved.
Respect the environment when disposing of lubricants and coolants.
Follow the manufacturer’s disposal instructions.
4