Optimum Optimum 3292385, Руководство по эксплуатации, Страница: 21 / 80

Version 1.0.4 - 2020-10-13 21 Translation of original instruction
SD500AV EN
SD500A
V_G
B
_3.
fm

Avoid places close to machines which cause chips or dust.

The installation site must be vibration-free, i.e. located away from presses, planing machi-
nes, etc.

The substructure must be suitable for metal band saws. Pay attention also to the load-bea-
ring capacity and evenness of the floor.

The substructure must be prepared in such a way as to ensure that, if any lubricant is used,
it cannot penetrate the floor.

Protruding parts - such as the dog, handles, etc. - must be secured, where necessary, by
means of on-site measures so that persons are not endangered.

Provide enough space for set-up and operating personnel and material transport.

Also bear in mind accessibility for installation and maintenance works.

Ensure adequate lighting is available (minimum value: 500 Lux, measured at the tool tip). In
the event of a lower level of lighting, additional illumination must be provided, e.g. by means
of a separate workplace light.
3.2.3 Assembly
INFORMATION
For deliveries from 2021 onwards, the machine is already fully assembled.

Check the horizontal orientation of the base of the metal belt saw with a spirit level. Equa-
lize unevenness using metal plates or other adequate material.

Mount the side parts of the machine stand to the front part and rear part using the supplied
fixing material.
Abb.3-2: Assembly drawing machine stand
3.2.4 Assembly of the hydraulic unit and the metal band saw

Place the machine stand on an appropriate foundation. Equalize eventual unevenness.