Optimum OPTImill MZ 25, Руководство по эксплуатации

Страница: 65 / 122

Version 1.0.4 - 2020-09-08 65 Translation of original instructions
MZ2S EN
MZ
2S
_G
B_5-
2.f
m
5.4.11 Play adjustment of the guide in the X axis
By adjusting the V-ledge to the left and/or right.

Dismantle the horizontal table.

Open the left and right bearing covers.
Perform measurement on the left:
If possible, use a dial gauge with drag pointer.

Fix dial gauge as shown.

Press the vertical milling table down on the left side and release.

Read the dial gauge.

Press the vertical milling table up on the left side and release.

Read the dial gauge, the total deviation must be less than 0.01mm.
In the event of a larger deviation, push the V-ledge with the adjusting screw slightly.
Perform measurement on the right:
Position the dial gauge on the right side and proceed using the same method.
Abb.5-9: Adjust guide, X axis
X
Y
Z
Dial gauge
Vertical milling table
V-ledge
Adjustment screw
Machine stand