Optimum OPTImill MZ 25, Руководство по эксплуатации

Страница: 64 / 122

Version 1.0.4 - 2020-09-08 64 Translation of original instructions
MZ2S EN
MZ
2S
_G
B_5-
2.f
m
5.4.10 Clearance adjustment of the guide of the machine stand in the Z axis
By adjusting the V-ledge at the top and/or bottom.

Dismantle the wiper releasing the adjusting screw.

Dismantle the chip tray and cover plate of the spindle.

Dismantle the horizontal table.
Perform measurement at the top:
If possible, use a dial gauge with drag pointer.

Position the dial gauge at the height of the top V-ledge.

Press the machine stand down on the left and the vertical table on the right side and
release.

Read the dial gauge, the deviation must be less than 0.01mm.
In the event of a larger deviation, push the V-ledge with the adjusting screw slightly.
Position the dial gauge on the underside and use the same method if the deviation is too large.
Abb.5-8: Adjust guide, Z axis
X
Y
Z
Adjustment screw
Dial gauge
Machine stand
V-ledge
Guide, milling table