Version 1.2.8 - 2020-08-03
51
Translation of original operating manual
MT50
GB
MT
5
0_GB
_5.
fm
First after 3
months then
every
6 months
F
eed
gea
r
Oil change
For oil change use an appropriate collecting tray of suffi-
cient capacity.
Travel the table in the rapid mode to-and-fro the oil heats
up and easily penetrates from the drain opening.
Unscrew the screw from the drain hole.
Img.6-7:
Drain hole vertical gear
Unscrew the screw from the filler hole.
Img.6-8:
Filler hole feed gear
Close the drain hole if no more oil drains.
Fill up to the middle of the reference mark of the oil sight
glass into the filler hole using a suitable container.
First after 20
working opera-
tions, then
every months
V-
belt
Horizo
ntal mill
ing
Check,
Readjusting
Check if the V-belts are porous or worn.
Press the finger on the V-belt. The V-belt should push
through by about 5 mm at a force of about 30 Newton (3
kg).
„Img.5-3: V-belt horizontal milling“ on page 32
Interval
Where?
What?
How?
Drain hole
Filler hole
