Version 1.2.8 - 2020-08-03
31
Translation of original operating manual
MT50
GB
MT
5
0_GB
_4.
fm
Push button coolant pump "ON"
Switches the coolant pump on.
Push button coolant pump "OFF"
Switches the coolant pump off.
Push button control "ON" and "Operating control lamp"
Switches the control on.
Main switch
Interrupts or connects the power supply to the machine control.
5.3
Switching on the milling-machine
ATTENTION!
Wait until the milling machine has come to a complete halt before changing the rotation
direction using the rotation direction switch.
Switch on the main switch.
If required, turn the EMERGENCY STOP button to the right in order to release the push
button.
Close spindle protection system.
INFORMATION
The control can be switched on only when all actuators such as the feed lever is in
neutral position.
Switch the control on.
Press the push button "Start" for vertical milling or horizontal milling and select the rotational
direction of spindle.
The milling-machine switches on and turns in the preselected rotation direction.
5.4
Switching off the milling-machine
Press the push button "OFF" for vertical milling or horizontal milling.
For a long-term standstill of the milling-machine switch it off at the main switch.
5.5
Inserting a tool
The milling spindle is equipped with an SK40 support and a draw-in bar M16.
Clean the conical support in the milling head.
Clean the taper of your tool.
Check if the inserts are firmly seated.
Position the tool holder including the tool from the bottom into the tapper support of the mill-
ing spindle.
Screw the draw-in bar in the cone of the tool holder.
Tighten the draw-in nut.
