OPTIMUM
M A S C H I N E N - G E R M A N Y
20
12
Safety
Version 1.0.1 dated 30 / 08 / 2012
Page 14
Original operating instructions
MH28V
GB
1.11
For your own safety during operation
WARNING!
Before activating the drilling-milling machine, double-check that this will not endanger
other people or cause damage to equipment.
Avoid any unsafe working practises:
Make sure your work does not endanger anyone.
The instructions in this manual need to be observed during assembly, handling, mainte-
nance and repair.
Use protective goggles.
Switch off the drilling-milling machine before measuring the workpiece.
Do not work on the drilling-milling machine if your concentration is reduced, for example,
because you are taking medication.
Stay on the drilling-milling machine until the working spindle has come to a complete halt.
Use the prescribed protective equipment. Make sure to wear a well-fitting work suit, when
necessary, a hairnet.
Do not use protective gloves during drilling or milling work.
Unplug the shockproof plug from the mains, before changing the tool.
Use suitable devices for removing drilling and milling chips.
Make sure your work does not endanger anyone.
Clamp the workpiece tightly before activating the drilling-milling machine.
In the description of work with and on the drilling-milling machine we highlight the dangers
specific to that work.
1.12
Disconnecting and securing the drilling-milling machine
Pull out the mains plug before starting maintenance and repair work.
1.13
Using lifting equipment
WARNING!
Use of unstable lifting equipment and load suspension devices that break under load
can cause very serious injury or even death.
Check that the lifting equipment and load suspension devices are of sufficient load
capacity and in perfect condition.
Observe the rules for preventing accidents issued by your association for the
prevention of occupational accidents and safety in the workplace or other inspection
authorities.
Hold the loads properly.
Never walk under suspended loads!
