OPTIMUM
M A S C H I N E N - G E R M A N Y
Version 1.3.0 dated 2016-12-16
Page 13
Original operating instructions
MF2 Vario
GB
INFORMATION
Use the following table in order to organize the checks.
1.11
Personnel protective equipment
For certain work personal protective equipment is required.
Protect your face and eyes: Wear a safety helmet with facial protection when performing works
where your face and eyes are exposed to hazards.
Use protective gloves when handling pieces or tools with sharp edges.
Use safety shoes when you assemble, disassemble or transport heavy components.
Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).
Before starting work make sure that the prescribed personnel protective equipment is available
at the working place.
CAUTION!
Dirty or contaminated personnel protective equipment can cause diseases. Clean it each
time after use and once a week.
1.12
Safety during operation
WARNING!
Before activating the milling-machine assure yourself that this will neither endanger
other personnel nor cause damage to equipment.
Avoid any unsafe working practices:
The instructions mentioned in these operating instructions have to be strictly observed dur-
ing assembly, operation, maintenance and repair.
Wear safety goggles.
Switch off the milling machine machine before measuring the workpiece.
Do not work on the milling-machine, if your concentration is reduced, for example, because
you are taking medication.
General check
Equipment
Check
Protective covers
Mounted, firmly bolted and not damaged
Signs,
Markings
Installed and legible
Date:
checked by (signature):
Functional check
Equipment
Check
EMERGENCY-STOP
switch
When the EMERGENCY-STOP button is activated, the milling-machine
should switch off. Make sure that it is only possible to restart the
machine if the EMERGENCY STOP push button is unlocked and the
main switch was activated.
Date:
checked by (signature):
