Optimum OPTidrill RD 4, Руководство по эксплуатации

Страница: 49 / 80

OPTIMUM
M A S C H I N E N - G E R M A N Y
Technical specification
Version 1.0 dated 2017-03-13 Page 49 Original operating instructions
RD4 GB
R
D
4_
GB
_2.
fm
5.1 Emissions
Measurement according to operating conditions
The noise development (emission) of the radial drilling machine is 73 dB(A) at a rotary speed of
1385 rpm, measured at a metre's distance from the gearbox at a height of 1.6m when the
machine is idling.
The noise development (emission) of the radial drilling machine is 70 dB(A) at a rotary speed of
1385 rpm, measured at a metre's distance from the gearbox at a height of 1.6m when the
machine is idling.
If the radial drilling machine is installed in an area where various machines are in operation, the
noise exposure (immission) on the operator of the radial drilling machine at the working place
may exceed 80 dB(A).
INFORMATION
This numerical value was measured on a new machine under the operating conditions specified
by the manufacturer. The noise behaviour of the machine might change depending on the age
and wear of the machine.
Furthermore, the noise emission also depends on production engineering factors, e.g. speed,
material and clamping conditions.
INFORMATION
The specified numerical value represents the emission level and does not necessarily a safe
working level.
Though there is a dependency between the degree of the noise emission and the degree of the
noise disturbance it is not possible to use it reliably to determine if further precaution measures
are required or not.
The following factors influence the actual degree of the noise exposure of the operator:

Characteristics of the working area, e.g. size of damping behaviour
,

other noise sources, e.g. the number of machines,

other processes taking place in proximity and the period of time, during which the operator
is exposed to the noise.
Minimum distance from the spindle nose to the surface of
the machine base [mm]
260
Environmental conditions temperature +5 to +40 °C
Environmental conditions of rel. humidity 30% to 95% at 40°C ; 90 % at 20°C
Environmental conditions storage and transport -25°C to +55 °C
Operating material

"Lubricant“ on page 71
Spindle gear Mobilgear 626
Gear for lifting device of
cantilever
Mobilgear 626
Lubricator Mobilgear 626
Spindle grease nipple Water repellent grease,
Mobilux EP 0
or
Mobil Greaserex 47
Cantilever screw spindle
Cooling lubricant
Water mixable, nebular
arm, high flash point,
nitrite content of the emul-
sion is less than 20 mg/l