Safety
Version 2.1.1 - 2020-07-27
15
Translation of original instruction
B40 GSP
EN
B40G
SP_
GB_1
.f
m
1.11
Individual protection gear
For certain work individual protection gear as protective equipment. This includes:
Safety helmet,
Protective goggles or face guard,
Protective gloves,
Safety shoes with steel toe caps,
Ear protection.
Before starting work, make sure that the prescribed individual protective equipment is available
in the workplace.
CAUTION!
Dirty or contaminated personnel protective equipment can cause diseases.
Clean your individual protection gear
after each use,
regularly, at least once a week.
Personal protective equipment for special works
Protect your face and eyes: Wear a safety helmet with facial protection when performing works
where your face and eyes are exposed to hazards.
Use protective gloves when handling pieces with sharp edges.
Use safety shoes when you assemble, disassemble or transport heavy components.
1.12
Safety during operation
We specially point out the specific dangers when working with and on the geared drill.
WARNING!
Before switching on the geared drill make sure that there are no
no dangers generated for persons,
not cause damage to equipment.
Avoid any risky working practices:
Make sure that nobody is endangered by your work.
The instructions mentioned in these operating instructions have to be strictly observed dur-
ing assembly, operation, maintenance and repair.
Do not work on the geared drill, if your concentration is reduced, for example, because you
are taking medication.
Functional check
Equipment
Check
OK
EMERGENCY-STOP
push button
After actuating an EMERGENCY STOP push button the geared
drill must be switched off.
Drill chuck protection
The geared drill must only be switched on, if the drill chuck
protection is closed. The engine must switch off when the drill
chuck protection is opened during operation.
Date:
checked by (signature):