Optimum B50 GSM, Руководство по эксплуатации

Страница: 12 / 70


2014
US
Page 12 Geared drill B50 GSM Version 1.0.3 22 / 07 / 2014
Safety
OPTIMUM
M A S C H I N E N - G E R M A N Y
1.7.3 Drilling table
There are T-Slots in the drilling table for the
T-slot nuts.
WARNING!
Risk of injury from parts flying off at
high speed. Secure the piece firmly on
the drilling table.
Fig. 1-3: Drilling table
1.7.4 Drill chuck guard

Adjust the drill chuck guard to the requi-
red height.

Move the drill chuck guard into place
before you start drilling.

The geared drill can only be activated as soon
as the drill chuck guard been closed.
Fig. 1-4: Drill chuck guard
1.7.5 Prohibitive, warning and information labels
INFORMATION
All warning labels must be legible. Check them regularly.
1.8 Safety check
Check the geared drill at least once per shift. Inform the person responsible immediately of any
damage, defect or change in operating function.
Check all safety devices

at the beginning of each shift (with the machine stopped),

once a week (with the machine in operation),

after every maintenance and repair operation.
Check that prohibitive, warning and information labels and the markings on the geared drill

can be identified (if not, clean them),

are complete.
INFORMATION
Use the following table for checking.
T-Slot for T-slot nuts
( 18 mm )
Drill chuck guard