Optimum 3403020, Руководство по эксплуатации

Страница: 13 / 102

Safety
Version 1.0.2 - 2020-07-20 13 Translation of original instruction
TM3310 | TM3310D EN
T
M
3310_
GB_1
.f
m
1.11 Personal protective equipment
For certain work personal protective equipment is required.
Protect your face and your eyes: Wear a safety helmet with facial protection when performing
work where your face and eyes are exposed to hazards.
Wear protective gloves when handling pieces with sharp edges.
Wear safety shoes when you assemble, disassemble or transport heavy components.
Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).
Before starting work make sure that the required personnel protective equipment is available at
the work place.
CAUTION!
Dirty or contaminated personnel protective equipment can cause illness. It must be
cleaned after each use and at least once a week.
1.12 Safety during operation
We provide information about the specific dangers when working with and on the lathe in the
descriptions for these types of work.
WARNING!
Before activating the lathe ensure that this will neither endanger other persons nor
cause damage to equipment.
Avoid any unsafe work methods:

Make sure that your work does not endanger anyone.

Clamp the workpiece tightly before activating the lathe.

Observe the maximum lathe chuck opening.
General check
Equipment Check OK
Guards Mounted, firmly bolted and not damaged
Signs,
Markers Installed and legible
Functional check
Equipment Check OK
Emergency-stop button After activating the emergency stop button, the control voltage on the lathe will
shut off. The spindle continues to rotate for a while, depending on the mass
moment of inertia of the spindle and workpiece.
Positions switch
Lathe chuck protection The spindle drive of the lathe must only be switch on if the lathe chuck
protection is closed.
Switch on protective
cover on the headstock The spindle drive of the lathe must only be switch on if the protective cover of
the headstock is closed.