OPTIMUM
M A S C H I N E N - G E R M A N Y
Operation
Version 1.0.1 dated 2016-02-23
Page 45
Original operating instructions
MZ4
│
MZ4V
GB
4.14
Clamping the tool
WARNING!
When milling, the seat cone must always be secured with the drawbar. A simple
connection with the taper bore of the work spindle without using the drawbar is not
permissible for milling. The cone connection is released by lateral pressure. Injuries may
be caused by flying parts.
ATTENTION!
The conical seat of the tool and spindle sleeve must be free of grease and dirt.
ISO 40 tool holder, M16 drawbar.
When vertical milling and horizontal milling, the tool is clamped with a drawbar.
Dismantle protective cap, drawbar.
Vertical milling - clamp tool from above via the drawbar with a 22mm wrench.
Refit protective cap, drawbar.
Horizontal milling - clamp tool via the drawbar with the rotating device.
4.15
Adjusting spindle guard
When drilling, adjust the spindle guard to
the appropriate height with the spindle
sleeve lever.
When milling with closed protective hous-
ing, the spindle guard can be set to its top
position.
INFORMATION
The spindle rotation is only released
when the spindle guard is closed.
Clamp tool:
for horizontal milling
Clamp tool:
for vertical milling
Spindle sleeve lever
Close spindle guard
