OPTIMUM
M A S C H I N E N - G E R M A N Y
Assembly and commissioning
Version 1.0.1 dated 2016-02-23
Page 26
Original operating instructions
MZ4
│
MZ4V
GB
3.2
Transport
WARNING!
Severe or fatal injuries may occur if parts of the machine tumble or fall down from the
forklift truck or from the transport vehicle. Follow the instructions and information on
the transport box.
Note the total weight of the milling machine.
Only use transport devices and load suspension gear that can hold the total weight of
the milling machine.
WARNING!
The use of unstable lifting and load suspension equipment that might break under load
can cause severe injuries or even death. Check that the lifting and load suspension gear
has sufficient load-bearing capacity and that it is in perfect condition.
Observe the accident prevention regulations issued by your Employers Liability
Insurance Association or other supervisory authorities applicable to your company.
Fasten the loads carefully.
Never walk under suspended loads!
3.3
Load suspension point
WARNING!
Before lifting the milling machine, check that all clamping screws of the milling table and
the spindle head bearing are tightened.
The milling machine is lifted by both eyebolts using a fork-lift truck or crane.
Screw the two eyebolts included in the delivery into the milling head.
The clamping screws of the milling table and the spindle head bearing must be tightened.
Weights
"Installation plan“ on page 28
Weight of the milling machine “Total weight [kg]“ on page 21
2.5 t
