Version 1.0.5 - 2021-01-29
94
Translation of original instruction
MH50G
│
MH50V
EN
M
H
50
G
_M
H
50
V
_
GB
_
4.
fm
4.15
Swivelling the milling head
The milling head can be swivelled to the right and to the left.
Loosen 2 fastening screws on the milling head.
Turn the drill-mill head clockwise to the desired position.
Retighten the fastening screws.
INFORMATION
The milling head should be aligned after resetting to the initial position with a dial indicator so
that holes can be produced with the spindle sleeve at a right angle. Set the zero degree angle
step using your set-up.
ATTENTION!
The drill-mill continues significantly further and also swivels in a different direction. By
continuing to swivel, gear oil may seep from the ventilation hole.
A
B
Zero degree angle step