Safety
Version 1.4.3 - 2020-12-14
12
Translation of original instruction
BF16V
EN
BF16V_
G
B_
1.f
m
1.9.3
Milling chuck protection
Adjust the protective equipment to the
correct height before you start working.
To do so, detach the clamping screw,
adjust the required height and re-tighten
the clamping screw.
A switch is integrated in the fixture of the
spindle protection which monitors that the
cover is closed.
INFORMATION
You cannot start the machine if the
spindle protection is not closed.
Fig.1-3:
Separating protective equipment
1.10
Safety check
Check the drilling-milling machine in regular intervals.
Check all safety devices
before each operation,
once a week (with the machine in operation),
after every maintenance and repair work.
1.11
Personnel protective equipment
For some works you need personnel protective equipment as protective equipment.
Protect your face and eyes: Wear a safety helmet with facial protection when performing works
where your face and eyes are exposed to hazards.
Clamping screw
General check
Equipment
Check
OK
Protective covers
Mounted, firmly bolted and not damaged
Signs,
Markings
Installed and legible
Functional check
Equipment
Check
OK
EMERGENCY-STOP push
button
When the EMERGENCY-STOP button is activated, the drilling-milling machine
should switch off. Make sure that it is only possible to restart the machine if the
EMERGENCY STOP push button is unlocked and the ON switch was
activated.
Separating protective
equipment around the drilling
milling spindle
The drilling-milling machine may switch on only when the safety device is
closed.
