Version 1.0.4 - 2020-12-15
13
Translation of original operating manual
MH25SV
EN
MH
25
SV
_GB_
1.
fm
1.6.5
Additional requirements regarding the qualification
The following additional requirements apply for work on electrical components or equipment:
They may only be performed by a qualified electrician or person working under the instruc-
tions and supervision of a qualified electrician.
Before beginning work on electrical parts or equipment, the following measures must be taken
in the order listed below:
disconnect all poles.
secure against restarting,
Ensure that there is no voltage.
1.7
Operator positions
The operator’s position is in front of the milling machine.
1.8
Safety measures during operation
CAUTION!
Danger due to inhaling dust and mist that is hazardous to health.
Depending on the material to be processed and the additional resources used, dust or
mist may be generated that is hazardous to your health.
Make sure that the dust and mist generated that is hazardous to health are safely
vacuumed at their point of origin and extracted from the working area or filtered. To
accomplish this, use a suitable extraction unit.
CAUTION!
Risk of fire and explosion by using flammable materials or cooling lubricants.
Before processing inflammable materials (e.g. aluminium, magnesium) or using inflammable
auxiliary materials (e.g. chemical spirits) it is necessary to take additional preventive measures
in order to safely avoid health risks.
1.9
Safety devices
Use the milling machine only with properly functioning safety devices.
If there is a failure on the safety device or if it is not functioning for any reason, stop the milling
machine immediately.
It is your responsibility!
If a safety device has been deactivated or is defective, the milling machine can only be used
again if you
eliminate the cause of the defect,
have verified that there is no danger that could result for people or property.
WARNING!
If you bypass, remove or deactivate a safety device in any other way, you are
endangering yourself and other personnel working with the milling machine. The
possible consequences include:
Injuries due to components or workpieces flying off at high speed,
contact with rotating parts,
fatal electrocution.
WARNING!
The separation guard made available and delivered together with the machine is designed to
reduce the risk of workpieces or scraps from the tools or workpieces being expelled, but not to
