Maintenance
Version 1.1.2 - 2022-02-24
74
Translation of original instruction
S 131 GH
EN
S131
GH_GB
_6.
fm
6
Maintenance
In this chapter you will find important information about
Inspection
Maintenance
Repair
of the metal band saw.
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for
operational safety,
failure-free operation,
long service life of the metal band saw and
the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
ENVIRONMENTAL PROTECTION
Make sure that the coolant lubricants and oils are not split on the floor.
Clean up any spilt liquid or oils immediately using proper oil-absorption methods and dispose of
them in accordance with current environmental protection regulations.
Collect leakages
Do not re-introduce liquids spilt outside the system during repair or as a result of leakage from
the reserve tank; collect them in a collecting container for disposal.
Disposal
Never dump oil or other environmentally hazardous substances which are harmful to the
environment in water inlets, rivers or channels.
Used oils must be delivered to a collection centre. Please consult your supervisor for further
information on your nearest collection point.
6.1
Safety
WARNING!
The consequences of incorrect maintenance and repair work may include:
very serious injury to personnel working on the metal band saw,
damage to the metal band saw.
Only qualified staff should carry out maintenance and repair work on the metal band
saw.
Use the prescribed protective equipment.
