Operation
Version 1.1.2 - 2022-02-24
72
Translation of original instruction
S 131 GH
EN
S131
GH_GB
_5.
fm
5.9
Speed of saw belt
WARNING!
Pull out the mains plug before you open the protective cover. Close and screw down the
protective cover after each change of speed.
5.9.1
Speed setting
Disconnect the metal band saw
from the power supply.
Slacken the V-belt with the
tensioning screw and Allen screw
on the motor.
Place the V-belt in the required
position on the pulleys.
Tighten the V-belt with the
tensioning screw and Allen screw
on the motor.
Img.5-7:
Speed setting
Check the tension in the V-belt. The
tension in the V-belt is correct if you
can push it approximately 1cm with
your finger.
Close and screw down the protective
cover.
Img.5-8:
Release / tense V-belt
INFORMATION
You cannot start the machine if the protective cover is not closed.
ATTENTION!
Watch for the proper tension of V-belts. Too heavy or too low tension of the belt can
cause damage.
Protective cover
V-belt
Motor
Tensioning screw
