Optimum 3290360, Руководство по эксплуатации

Страница: 27 / 92

Version 1.0.3 - 2020-10-13 27 Translation of original instruction
SD351AV EN
SD351A
V_G
B
_3.
fm
3.4.6 Material stop

Insert the guide rod into
the location hole.

Clamp the motion rod with
the front clamp screw.

Mount the material stop
on the limit stop fixture
and clamp it using the
clamping screw.

Adjust the position of the
guide rod in the seat hole
using the scale by means
of the clearance between
the depth stop and the
saw blade.
Img.3-7: Material stop

Clamp the limit stop fixture with the front clamp screw.
3.4.7 Coolant collecting trays

Mount the drip plate, if necessary.
INFORMATION
There is no tapped hole prepared in the machine substructure. Fix the drip plate to the position
which corresponds best to the use of the metal belt saw itself and the local conditions.
If necessary, put the drip plate in front of the collecting trays in order to collect the coolant which
discharges over the workpiece.
3.4.8 Cleaning and lubricating

Remove the anti-corrosive agents on the metal belt saw which had been applied for trans-
portation and storage. Therefore, we recommend you to use paraffin.

Do not use any solvents, thinner or other cleaning agents which could corrode the varnish
on the metal belt saw. Observe the indications and notes of the manufacturer for cleaning
agents.

Oil all blank machine parts using an acid-free lubricating oil.

Grease the metal belt saw according to the lubrication chart.
Clamping screw
front
Material stop
Clamping screw
Limit stop fixture
Clamping screw
Motion road with
scale
Clamping screw
front
Location hole