Optimum 3071035, Руководство по эксплуатации

Страница: 31 / 86

Version 1.0.7 dated 2019-09-25 Page 31 Translation of the original instructions
DM35 │ DM35V │ DM35PF │ DM36VT │ DM38VF │ DM50 │ DM50V │ DM50PM │ DM60V │ DM98V
GB
D
M
35
xx
_
DM3
6V
T
_D
M38
V
F
_DM
50
xx
_D
M
60
V
_DM
98
V_
G
B
.f
m
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
supplied is through a public low voltage supply system. In these areas, it may be difficult
to guarantee electromagnetic compatibility due to conducted and emitted interference.
4 Operation

Permanent operation of the magnetic drill of more than 2 to 3 hours is not permitted. There
is a risk of fire due to high load. The magnetic drill first has to be cooled down before it
starts to be run continuously again.

If the drill bit jams, the magnetic drill must be shut down immediately.

Operation of the magnetic drill in an open environment is not permitted.

For magnetic drills with automatic feed, when starting work, the lowest speed and the low-
est feed must be selected first.

Drilling into non-magnetisable surfaces is only possible if a steel plate of a sufficient size
has been fastened to the non-magnetisable surface.

First switch on the electromagnetic and then the drilling spindle. When switching off, first
switch off the drilling spindle and then the electromagnet.

For drilling work in a vertical position overhead, two people must be present.

The securing belt must also be used when working with horizontal drilling work, to secure
the magnetic drill against falling from the elevated working locations.

The manually-operated drill feed should not exceed 0.05 mm per rotation.

Only use a suitable core hole drill for the machining task envisaged.
Usable tools: Weldon type; Clamping of tools with 19mm cylindrical shank and lateral driving
surface similar to DIN 1835-B and DIN 6535-HB.
On magnetic drills with additional gear shift:
Only switch at standstill. If necessary, start the spindle for a short time and switch it off again.
Low gear speed: for hard materials, large drills, cutting tools, screw taps.
High gear speed: for soft materials, small drills, small cutting tools.
OPTIdrill DM36VT
Switching to left-hand rotation is done by additionally pressing the yellow pushbutton. The mag-
netic drill stops and changes the direction of rotation after about 3 to 5 seconds. Keep the push
button pressed to maintain the changed direction of rotation.
OPTIdrill DM35PF
Pull out the quill lever to activate the automatic feed. To deactivate the feed, push the quill lever
back in. By reactivating the feed, a return in the feed with reversal of the direction of rotation
takes place.
19mm
( 3/4" )
Gear stage