OPTIMUM Maschinen OPTIturn 3432420, Руководство по эксплуатации

Страница: 17 / 138

Safety
Version 1.0.5 - 2020-12-09 17 Translation of original instruction
TX4414 EN
T
X
4414
_GB
_1.
fm
1.11 Personal protective equipment
For certain work personal protective equipment is required.
Protect your face and your eyes: Wear a safety helmet with facial protection when performing
work where your face and eyes are exposed to hazards.


Wear protective gloves when handling pieces with sharp edges.


Wear safety shoes when you assemble, disassemble or transport heavy components.

Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).
Before starting work make sure that the required personnel protective equipment is available at
the work place.
CAUTION!
Dirty or contaminated personnel protective equipment can cause illness.
It must be cleaned after each use and at least once a week.
1.12 Safety during operation
We provide information about the specific dangers when working with and on the lathe in the
descriptions for these types of work.
WARNING!
Before activating the lathe ensure that this will neither endanger other persons nor
cause damage to equipment.
Avoid any unsafe work methods:

Make sure that your work does not endanger anyone.

Clamp the workpiece tightly before activating the lathe.

Observe the maximum lathe chuck opening.

Wear safety goggles.

Do not remove the turning chips by hand. Use a chip hook and / or a hand brush to remove
turning chips.

Clamp the turning tool at the correct height and with the least possible overhang.

Turn off the lathe before measuring the workpiece.

The instructions described in these operating instructions must be strictly observed during
assembly, operation, maintenance and repair.

Do not work on the lathe if your concentration is reduced, for example, because you are
taking medication.

Observe the accident prevention regulations issued by your Employers Liability Insurance
Association or other supervisory authorities applicable to your company.

Inform the supervisor about all hazards or faults.

Stay at the lathe until all movements have come to a complete standstill.

Use the prescribed personnel protective equipment. Make sure to wear a well-fitting work
suit and, if necessary, a hairnet.