Delivery, interdepartmental transport and unpacking
Version 1.0.1 - 2020-11-12
9
Translation of original instruction
GU35P
EN
GU35P
_GB
.f
m
Careful planning of internal transport is therefore essential.
3.2
Unpacking and connecting
The polishing machine is ready for operation. In order to obtain the correct direction of rotation,
the phase sequence must be changed if necessary. This is done at your three-phase connec-
tion or - if equipped with it - at the three-phase connector by changing the phase sequence.
3.3
Scope of delivery
Check the polishing machine immediately after delivery for transport damage, missing parts
and loose locking bolts. Compare the scope of delivery with the delivery note. Polishing wheels
are available in specialist shops or from our main catalogue.
3.4
Storage
ATTENTION!
Incorrect and improper storage might result in damage or destruction of electrical and
mechanical machine components.
Store packed and unpacked parts only under the intended environmental conditions.
Follow the instructions and information on the transport box.
Consult Optimum Maschinen Germany GmbH if the machine and accessories are stored for
more than three months or are stored under different environmental conditions than those spec-
ified here.
3.5
Set-up and assembly
3.5.1
Installation site requirements
Organise the working area around the polishing machine according to the local safety regula-
tions.
WARNING!
The polishing machine must be firmly connected to the substructure.
CAUTION!
Arrange the machine's connection cable in such a way that it will not cause a tripping
hazard.
INFORMATION
In order to achieve high levels of functionality and machining accuracy, as well as a long ser-
vice life of the machine, the set-up location should meet certain criteria.
The following points should be noted:
The device must only be installed and operated in a dry and well-ventilated place.
Avoid places close to machines which cause chips or dust.
The installation site must be vibration-free, i.e. located away from presses, planing
machines, etc.
The foundation must be suitable for the polishing machine. Also make sure that the floor
has sufficient load bearing capacity and is level.
Provide enough space for set-up and operating personnel and material transport.
Ensure adequate lighting is available (minimum value: 500 Lux, measured at the polishing
wheel). In the event of a lower level of lighting, additional illumination must be provided, e.g.
by means of a separate workplace light.
The power plug of the polishing machine must be readily accessible.
