Appendix
Version 1.0.1 - 2020-11-12
12
Translation of original instruction
GU35P
EN
GU35P
_GB
.f
m
5.2
Inspection and maintenance
INFORMATION
The bearing is lifetime-lubricated. It is not necessary to lubricate it again.
5.3
Replacing a polishing wheel.
Loosen the shaft nut.
Hold the shaft with a wrench to loosen the nut. Make sure you use the correct direction to
loosen the nut. Right side, right hand thread. Left side, left hand thread.
Pull off the polishing wheel and the retaining washer from the shaft by hand.
Check the new polishing wheel for visible damage prior to assembly.
5.4
Repair
Optimum Maschinen Germany GmbH accepts no liability nor does it guarantee against damage
and operating malfunctions resulting from failure to observe these operating instructions.
For repairs, only use
faultless and suitable tools only,
original parts or parts from series expressly authorised by Optimum Maschinen Germany
GmbH.
6
Appendix
6.1
Copyright
This document is protected by copyright. All derived rights are reserved, especially those of
translation, re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar
means and recording in data processing systems, either partial or total.
Subject to technical changes without notice.
6.2
Liability claims/warranty
Besides the legal liability claims for defects of the customer towards the seller, the manufac-
turer of the product, OPTIMUM GmbH, Robert-Pfleger-Straße 26, D-96103 Hallstadt, does not
grant any further warranties unless they are listed below or were promised as part of a single
contractual provision.
Liability or warranty claims are processed at OPTIMUM GmbH's discretion either directly or
through one of its dealers.
Any defective products or components of such products will either be repaired or replaced
Shaft nut
Thrust washer
Retaining washer
Drive shaft
Polishing wheel
