Operation
Version 1.0.1 - 2020-10-14
14
Translation of original instruction
GBS75 | GBS150
EN
GBS
75_G
BS15
0_G
B.
fm
3.8
First commissioning
ATTENTION!
Before commissioning the machine, all bolts, fastenings and protections must be
checked and retightened as necessary!
CAUTION!
Danger from the use of unsuitable sanding belts. Only use abrasive belts with the correct
width and length.
WARNING!
First commissioned of the belt grinder by inexperienced personnel constitute a risk to
personnel and equipment.
We do not accept any liability for damages caused by incorrectly performed commissioning.
Personnel qualification on page 6
4
Operation
The step switch allows you to switch from a low belt speed to a higher belt speed.
If the drive is overloaded, the motor-protective circuit-breaker may trip. The motor-protective cir-
cuit-breaker is reset by pressing the button on the underside of the drive control panel.
4.1
Adjusting the tilt angle
CAUTION!
Danger of tipping Loosen the clamping lever only slightly. There are small points on the
shaft to engage the desired angle.
Hold the belt grinder and release the clamping lever.
Adjust the angle of inclination according to the intended use.
Tension the clamping lever again.
