OPTIMUM Maschinen 3034350, Руководство по эксплуатации

Страница: 10 / 72

Safety
Version 1.0.2 - 2020-07-06 10 Translation of original instruction
DH 40CT | DH 40CTP
EN
D
H
4
0
CT_DH40CTP_G
B_1
.f
m
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must

be duly qualified,

and strictly follow these operating instructions.
In the event of improper use

there may be a risk to personnel,

there may be a risk to the machine and other material values,

the functionality of the drilling milling machine may be compromised.
Always disconnect the drilling milling machine, when cleaning or maintenance work is being
carried out.
WARNING!
The drilling milling machine may only be used with fully functional safety devices.
Disconnect the drilling milling machine immediately, whenever you detect a failure in the
safety devices or when they are not fitted!
All additional devices installed by the operator must be equipped with the stipulated
safety devices.
This is your responsibility being the operating company!

Safety devices on page 12
CAUTION!
The drilling and milling machine DH40 CTP is equipped with an automatic quill feed. The
higher the speed at the quill, the higher the automatic feed.
1.6 Qualification of personnel
1.6.1 Target group
This manual is addressed to

the operating companies,

the operators,

the maintenance personnel.
Consequently, the warning notes refer both to the use of the drilling milling machine and to its
maintenance.
Determine clearly and explicitly who will be responsible for the different activities on the
machine (operation, setting up, maintenance and repair).
Unclear responsibilities constitute a safety risk!
Always lock the main switch after switching off the drilling milling machine. This will prevent it
from being used by unauthorized persons.
INFORMATION
Unclear responsibilities constitute a safety risk!
The qualifications of the personnel for the different tasks are mentioned below:
Operator
The operator has been instructed by the operating company regarding the assigned tasks and
possible risks in case of improper behaviour. Any tasks which need to be performed beyond the
operation in standard mode must only be performed by the operator, if so indicated in these
instructions and if the operator has been expressively commissioned by the operating com-
pany.