Read and understand all instructions before using the equipment.
2.
This equipment is for indoor use in moderate climates only. Never use the equipment in damp or wet
conditions. Avoid excessive heat, humidity, dust & vibration.
3.
To reduce risk of electric shock, do not use where the projector may be subjected to dripping or splashing
liquids. Never immerse products in any liquids.
4.
Connect only to a power supply with a voltage corresponding to that printed on the projector.
5.
This projector must always be connected to a grounded (earthed) electricity supply.
6.
Always use the mains lead supplied suitable for your country.
7.
Do not operate appliance with a damaged cord, or if the appliance has been dropped, or damaged, until it
has been examined by a quali
fi
ed service person.
8.
If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance must
be used. Cords rated for less amperage than the appliance may overheat.
9.
To avoid the possibility inadvertent resetting of the thermal cutout, this appliance must not be supplied via
an external switching device, such as a timer, or connected to a circuit that is regularly switched on and o
ff
10.
Ensure all cables are routed safely to avoid tripping or pulling: also avoid sharp bends, pinches and
contact with hot surfaces.
11.
The appliance power switch has the symbols ‘O‘ indicating ‘OFF’ and ‘l‘ indicating ‘ON‘.
12.
Do not obstruct any ventilation openings. To avoid thermal ‘cut out’ or heat damage make sure all air
inlets and outlets are clear of obstruction before and during use.
13.
Children over 8 years old and persons with reduced physical, sensory or mental capabilities or lack
of experience and knowledge can use the appliance if under close supervision or given instructions
how to use the appliance safely and they understand the hazards involved. Do not leave unattended or
allow children to play with the appliance or allow them to clean or carry out any maintainance work.
14.
The use of an accessory attachment not recommended by the manufacturer may cause a risk of
fi
re,
electric shock, or injury.
15.
DO NOT USE THE PROJECTOR AT AN ANGLE OF MORE THAN 90° FROM HORIZONTAL as this
may cause an e
ff
ect or e
ff
ect accessory to separate from the projector, fall and break which may also cause
injury.
16.
During focusing beware of rotating the projection lens too far out, as this can cause the lens to separate
from the projector, and may drop and break which could cause injury.
17.
Always disconnect appliance from electrical outlet when not in use or moving. Never yank cord to
pull plug from outlet. Grasp plug and pull gently to disconnect.
18.
To reduce the risk of electric shock - do not dismantle this appliance. Take it to a quali
fi
ed repairer
when servicing is required.
19.
Always unplug appliance from electrical outlet and allow to cool before any cleaning and/or servicing.
20.
After any maintenance or cleaning all parts must be absolutely dry before re
fi
tting.
21.
All procedures, described in the maintenance section, must be carried out by quali
fi
ed service
personnel under the authority of the manufacturers recognised agent.
Instructions
Important Safety Instructions and Warnings
Designed and Manufactured in the UK by [OPTI] Kinetics
1
SAVE THESE INSTRUCTIONS
When using your projection equipment always observe the following safety precautions:
GOBO40
