Optex SC-U1, Руководство по эксплуатации

Страница: 78 / 92

78
Cleaning
Set the standby time after cleaning.
The settings are to activate the cleaning device using a relay output ("Cleaning output setting"
P.47).
The measurement value is retained (held) during post-cleaning standby.
The setting range is shown below.
Select [Post-cleaning Standby] using ,
and press .
2
1
&OHDQLQJ
6HQVRU6HOHFW
㸯 S+ࠉ6(S+'
㸰 7XUE7&'
㸱 '2'26
㸲
ࠉ $//
Output item Sensor model
Sensor channel
&OHDQLQJ
㸱 '2'26
0$18$/&/($1,1*
&OHDQLQJ,QWHUYDO5/<PLQ
&OHDQLQJ$FWLYDWLRQࠉVHF
3RVWFOHDQLQJ6WDQGE\VHF
Select a digit by and value by
, and press .
The display returns to the cleaning menu.
3
&OHDQLQJ
㸱 '2'26
3RVWFOHDQLQJ6WDQGE\
ࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉVHF
u
Post-cleaning Standby
On the sensor selection display, select a
sensor to set using
, and press .
The cleaning menu is displayed.
Post-cleaning standby setting must be set for each
sensor.
If [ALL] is selected, the setting is not available.
When a value outside the set range is entered, a short
beep sounds.
Press
simultaneously while entering a value
to reset to the factory default setting.
By pressing or , the value returns to the one
before changing it.
Item Setting range Factory default setting
Post-cleaning Standby 10 to 180 seconds (by 10 seconds) 30 seconds