Optex SC-U1, Руководство по эксплуатации, Страница: 33 / 92

33
4-20 mA Setting
On the channel selection display, switch
between pages using , select a
channel to set using , and press .
u
Signal output range lower limit
Select a digit by and value by
, and press .
The display returns to the setting item selection
menu.
To proceed, go to step 2 of "Signal output range
upper limit" P.34.
3
P$6HWWLQJ
&+
2XWSXW,WHP6HOHFW
㸱 '2'26
/RZ/LPLW6HWWLQJ
P$ PJ/
+LJK/LPLW6HWWLQJ
P$ PJ/ !
Select [Low Limit Setting] using ,
and press .
The current setting value is displayed.
2
P$6HWWLQJ
&KDQQHO6HOHFW
2XWSXW,WHPP$P$
&+
㸯 S+S+
&+㸱'2PJ/
&+ 㸱 7HPSΥ
&+ 㸰 7XUE)78
!
Output item
Sensor channel
P$6HWWLQJ
&+ 㸱 '2'26
/RZ/LPLW6HWWLQJ
P$
ࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉPJ/
For the item selected in the "Output Item Select", set measurement value to output at lower
limit (Lo, 4 mA).
The setting item selection menu is displayed and the
current setting of the selected channel is displayed.
1
When a value outside the set range is entered, a short
beep sounds. The setting range varies depending on
the measurement item. Refer to the instruction manual
of each sensor.
Press
simultaneously while entering a value
to reset to the factory default setting.
By pressing or , the value returns to the one
before changing it.