Optelec
ClearView
+
English
17
4.
Operation
When using the ClearView
+
, place your hands on the wrist
support at the front of the table for easier access to the control
buttons, and for steady table movement.
Operation
–
Switching ON / OFF
To power both the system and monitor, press the ON /
OFF button that is located right above the magnification
button on the reading table. The ClearView
+
will start up in
the same viewing mode as when it was powered off.
It takes about 10 seconds for the camera unit to initialize
before it displays an image. Within about 1 minute, the
ClearView
+
system’s light source will achieve full brightness,
providing optimal image quality.
Please note
that a non-ClearView
+
monitor must be
switched on and off separately.
Adjusting the magnification
Locate the zoom button in the centre of the table,
and turn it clockwise to increase the magnification,
and counter-clockwise to decrease it.
