Network Switch
OptReboot
Network Switch
STATUS
RESET
ETHERNET
CELL
ON
S
I
G
N
A
L
Network Switch
OptConnect Gateway
OptReboot works seamlessly with an existing OptConnect cellular gateway, enabling
you to remotely reboot your ATM, Kiosk, Point of Sale, or any other similar device from
an internet connected computer, tablet, or smart phone. Your OptReboot comes
pre-configured and simply needs to be connected using the included cabling.
Locate An Available Ethernet Port: Looking at the back of the OptConnect cellular
gateway, determine if you have an open ethernet port.
Open the ATM’s lower cabinet to access the ATM’s and OptConnect gateway’s power
supply. The OptReboot is designed to be installed in this lower cabinet.
Connecting Network Connections
Connect Using A Network Switch: These steps are required only if your OptConnect
gateway’s ethernet port is occupied. The OptReboot is compatible with any network
switch (one may have been included in your shipment).
a) Disconnect your ATM, Kiosk, or other device from the OptConnect gateway.
Connect your
device’s ethernet
cable to a port on a
network switch.
Connect an ethernet
cable between
the OptReboot’s
ethernet port and a
port on the network
switch.
Connect an
ethernet cable
between the
OptConnect
gateway and the
networt switch.
b)
c)
d)
3a
If the ethernet port is already occupied by a connection to an ATM, Kiosk, or other
device, continue to step 3a. If the port is available, skip directly to step 3b.
See overall Network Connection diagram on back.
