OPT7 AuraLED™ Wheel Well Lighting Kit
Visit
www.OPT‐7.com
for additional products & support
For questions you may have, please contact
Support@OPT‐7.com
. We normally respond within 24 hours. (Monday‐Friday)
Step 1: Test The Strips
1. Connect all LED strips and extension cords to the control box.
2. Connect the control box to the car 12v adapter. Then, plug the adapter into any open power slot.
3. Turn the car ignition into the AUX position and push “ON” on the car adapter.
4. Using the included E‐Z Remote, test the various colors and patterns.
Step 2: Prepping The LED Strips
1. Starting with the front driver’s wheel, lift and set the car onto a lift stand.
Do NOT leave your car on any jack.
2. For ease of installation, remove the wheel.
3. Temporarily affix your Aura Strips into your wheel well by using the 3M tape on the back of each strip.
a. Make your rims glow: Place the LED strip behind the axle strut facing outward.
b. Make your tires glow: Place the strip on the top of the wheel well facing downward.
4. Once placed, steer the wheel all the way left and right to ensure at least 2” of clearance.
Before drilling holes for the more permanent U‐Clamps, get your kit connected by
following the steps below. This will allow you to test the light placement before making a final install.
Step 3: Connecting Your Kit Together
1. Near the wiring side of the strip, drill a ¾ inch hole in your car’s plastic fender for wiring.
2. Connect the extension cords to your strips and guide them towards the front of the car.
3. Run the cords through a pre‐existing hole in your car’s firewall into the driver foot well.
(Firewalls are usually located in the engine bay near the driver foot well)
4. Use provided zip ties to neatly mount and hide any loose wiring.
Make sure the cords are not touching any hot surfaces or moving parts.
5. Repeat steps 1‐5 for the remaining wheels
