3
E111471#1
INSTRUCTIONS
Assembling the water pump
1. Strar with the acrylic plate (A) and insert the 4 machine screws (10) up through the holes in the cor-
ners, as shown in diagram 3.
2. Asemble the turbine housing
(3) as shown using the machi-
ne screws.
The assembly must be ac-
curate otherwise the pump
may not work at a later stage
or the turbine will rub on the
sides! (see dia.4)
3. Insert the brass rod (7) throughthe middle hole in
the acrylic plate and then add the silicon tube (8)on
the other side. The acrylic sheet (B) with the turbine
facing down on the four fixing screws (10). (see dia 5)
Note!
The shaft must not stick. The shaft must turn easily in
the hole! If necessary drill out the hole to 3.1mm.
4. Set the distance tubes (6)
on the machine screws (10) (
see dia.6 )
Dia. 3
Dia. 4
Dia.6
Dia.5
5. Mount the motor (5) with the screws (11) on the
acrylic plate, (C)
Note:
The motor shaft must be able to turn freely
Dia. 7
6. Set the acrylic plate (C) with the motor at the top on the
fixing screws (10) so the 6mm holes on plate B+C lie on
top of each other. Join the motor shaft with the silicon
tube (8) (see dia.8)
Note:
Adjust the turbine so that it does not rub on the housing!
Dia.8
File the brass rod flat on either end and insert it with a hammer in the middle hole of the red turbi-
ne
A
B
