Opex OMATION 2112, Руководство пользователя

Страница: 7 / 14

Introduction 7
Omation Model 2112 User Manual - OPEX Corporation use only - not for distribution
2 Select either the “No Cut” (clockwise) or “Cut” (counterclockwise) position
on the Cut/No Cut Selector Knob.
3 Set the cut depth lever to the left (deep cut) or right (shallow cut). The
factory cut depth default settings are .020” (deep) or .012” (shallow).
However, the cut depth can be adjusted, as described in “Cutter
Adjustment” on page 9.
4 Press the Counter Reset button to reset the counter (if desired).
5 Load a handful of mail (approximately 50 pieces) onto the Envelope Feed
Hopper. Be sure to justify the side of the mail to be cut against the back of
the Feed Hopper. The Feed Thumper (a rotating cam) helps to jog the mail
for improved feeding.
6 Turn the On/Off Power Switch to the On position to start the machine.
7 The mail is singulated (separated one at a time) by the retard assembly.
8 The nip arm assembly guides the individual envelopes past the cutter and
to the output tray.
9 Once the Envelope Feed Hopper is empty, empty the output tray.
10 To continue processing, repeat the above steps.
Nip Arm Removal/Installation
The Nip Arm should be removed for clearing paper jams and cleaning the
machine.