Opex DS2200, Руководство пользователя

Страница: 81 / 90

Statistics 81
DS 2200 User Manual - OPEX Corporation use only - not for distribution
Performance Details statistics
The following table list the terms that appear in the Performance Details
section of the statistics report.
Note: All times noted in the formulas in this table are in seconds. For example,
if the Active Job Time appears as “00:01:49” then that means one minute
(60 seconds) plus 49 seconds, or 109 seconds.
The Rejects section lists the reasons for the rejected documents and how
many documents were rejected for each reason.
Table 4: Performance Details terms
Term Definition
Active Job
Time
Time the DS2200 was either actively running or was halted
due to a jam. Active Job Time is broken down by:
• Run Time
• Jam Time
Run Time Total run processing time.
Jam Time Total time the DS2200 was halted for a jam.
Idle Time
Time the Operator was in the Run Job window, but the
DS2200 was not processing pieces.
Table 5: Reasons for rejected items
Length Too
Long
Results when an image is longer than the maximum
allowable image size of the system or when outsorting is set
to reject an image longer than a defined length.
Length Too
Short Results when outsorting is set to reject an image shorter
than a defined length.
Gap Too Small
Results when the gap between pieces is shorter than the
minimum feed gap defined in the machine parameters.
Too Thin
Results when out sorting is set to reject a piece thinner than
a defined minimum allowable thickness.
Too Thick
Results when out sorting is set to reject a piece thicker than
a defined maximum allowable thickness.